Onkyo TX-NR1010 Instruction Manual page 65

■
Surround Back Ch
1ch:
Select if only one surround back speaker L is
connected.
2ch:
Select if two (left and right) surround back speakers
are connected.
Note
• If the "Surround Back" setting is set to "None", this setting
cannot be selected.
■
LPF of LFE
(Low-Pass Filter for the LFE Channel)
80Hz, 90Hz, 100Hz, 110Hz, 120Hz
Off:
Low-Pass Filter is not applied.
With this setting, you can specify the cutoff frequency of
the LFE channel's low-pass filter (LPF), which can be
used to filter out unwanted hum. The LPF only applies to
sources that use the LFE channel.
Note
• If you're using THX-certified speakers, select "80Hz".
■
Subwoofer Phase
0º
180º:
Moves the subwoofer phase.
Note
• If the "Subwoofer" setting is set to "No", this setting cannot be
selected.
■
Double Bass
This setting is NOT set automatically by
®
Audyssey MultEQ XT32 Room Correction and
Speaker Setup (➔ page 39).
On
Off(THX)
Turn this setting on to boost bass output by feeding bass
sounds from the front left, right, and center channels to
the subwoofer.
Note
• When the "Subwoofer" setting is set to "No" or the "Front"
setting to anything other than "Full Band", this setting is fixed to
"- - - - -".
• This setting is set to "On" automatically when the "Subwoofer"
setting is set to "1ch" or "2ch" and the "Front" setting is set to
"Full Band" for the first time.
• If you're using THX-certified speakers, select "Off(THX)".
En-65
Advanced Operations
Speaker Distance
This setting is set automatically by
Audyssey MultEQ XT32 Room Correction and Speaker
Setup (➔ page 39).
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener's ears as the sound designer intended.
■
Unit
feet:
Distances can be set in feet. Range: 0.2ft to 30.0ft in
0.2 foot steps.
meters:
Distances can be set in meters. Range: 0.06m to
9.00m in 0.06 meter steps.
(The default setting varies from country to country.)
■
Left, Front Wide Left, Front High Left, Center,
Front High Right, Front Wide Right, Right,
Surround Right, Surround Back Right, Surround
Back Left, Surround Left, Subwoofer 1,
Subwoofer 2
*1
Specify the distance from each speaker to your
listening position.
Note
• Speakers that you set to "No" or "None" in "Speaker
Configuration" cannot be selected (➔ page
• When the "Powered Zone 2" setting is set to "Yes" and Zone 2
is turned on, the surround back and front high speakers cannot be
used.
• When the "Powered Zone 3" setting is set to "Yes" and Zone 3
is turned on, the surround speakers cannot be used.
*1 If the "Subwoofer" setting is set to "1ch", this setting cannot
be selected (➔ page 64).
64).