Source Setup - Onkyo HT-RC460 Instruction Manual

■
TrueHD Loudness Management
Off
On
This setting specifies whether or not to apply the Late
Night processing on a Dolby TrueHD source.
Note
• When this setting is set to "Off", the Late Night function for
Dolby TrueHD sources is automatically fixed to "Off"
(➔ page 45).
DTS
■
Neo:6 Music
Center Image
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel stereo sources. With this
setting, you can specify by how much the front left and
right channel output is attenuated in order to create the
center channel.
Changing the value from "0" to "5" will spread the sound
of the center channel to left and right (outwards).
Theater-Dimensional
■
Listening Angle
Wide:
Select if the listening angle is greater than 30 degrees.
Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should be
equidistant from the listening position and at an angle close
to one of the two available settings.
Front left speaker Front right speaker
Listening angle: 30°
Note
Narrow
• For best results, we recommend setting "
"Wide" to 40°.
En-53

Source Setup

1 2 3
Items can be set individually for each input selector.
Preparation
Press the input selector buttons to select an input source.
Main Menu
Audyssey ®
The tone for each speaker is set automatically by
Audyssey 2EQ ® Room Correction and Speaker Setup.
To enable the following settings, you must first perform
the Room Correction and Speaker Setup
• These technologies cannot be used when:
– a pair of headphones is connected, or
– Direct listening mode is selected.
■
Audyssey
" to 20° and
Off
Movie:
Select this setting for movie material.
The Audyssey indicator will light.
Music:
Select this setting for music material.
The Audyssey indicator will light.
Note
• When "Audyssey Quick Start" has been used for measurement,
"Audyssey" cannot be selected.
• Audyssey equalizing does not work with DSD sources.
Advanced Operations
4 5
"Setup"
Source Setup
(➔ page 32).