Source Setup - Onkyo TX-NR1030 Advanced Manual

Direct
Make the settings for Pure Audio and Direct listening modes.
Setting Item Default Value
Analog Subwoofer Off
DSD DAC Direct Off
36
Setting Details
Set the output of low-frequency signals from the
subwoofer during playback in Pure Audio or Direct
listening mode.
"Off": No output
"On": Output
r The setting cannot be changed if "Subwoofer"
is set to "No".
Set processing of DSD (Super Audio CD) audio
signals performed by DSP when Pure Audio or
Direct listening mode is selected.
"Off": DSD signals are processed by the DSP.
"On": DSD signals are not processed by the DSP.

4.Source Setup

Adjust the volume level difference among the multiple devices connected to this unit,
rename an input selector, or adjust the image quality. The setting can be separately set to
each input selector button. When you select a desired input to check the video or audio,
start playback of the connected device.
AccuEQ Room Calibration
Setting Item Default Value
AccuEQ Room Off
Calibration
IntelliVolume
Setting Item Default Value
IntelliVolume 0 dB
Advanced Settings
Setting Details
Enable/disable the sound field set in automatic
speaker setup
"On": Enable this function
"Off": Disable this function
r In the following cases, the setting cannot be
changed:
– Automatic speaker setup is not performed.
– Headphones are connected.
Setting Details
Adjust the volume level difference between the
devices connected to the unit. Select a value
between "-12 dB" to "+12 dB".
Set a negative value (–) if the volume of the target
device is larger than the others and a positive
value (+) if smaller.
r This function is not effective in Zone 2/Zone 3.