Source Setup - Onkyo TX-NR828 Owner's Manual

■
TrueHD Loudness Management
Off
On
This setting specifies whether or not to apply the Late
Night processing on a Dolby TrueHD source.
Note
• When this setting is set to "Off", the Late Night function for
Dolby TrueHD sources is automatically fixed to "Off".
• When this setting is set to "Off", the Dialogue Normalization
information is not available for Dolby TrueHD sources.
DTS
■
Neo:6 Music
Center Image
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-
channel surround sound from 2-channel stereo
sources. With this setting, you can specify by how
much the front left and right channel output is
attenuated in order to create the center channel.
Changing the value from "0" to "5" will spread the
sound of the center channel to left and right
(outwards).
Audyssey DSX ®
■
Soundstage
–3dB to Reference to +3dB
With this setting, you can adjust the sound stage when
using Audyssey DSX.
Note
• This listening mode can be selected only when all the
following conditions are satisfied:
– The center speaker is connected.
– Either the front high or front wide speakers are connected.
– Powered Zone 2 is not in use.
Theater-Dimensional
■
Listening Angle
Wide:
Select if the listening angle is greater than 30
degrees.
Narrow:
Select if the listening angle is less than 30
degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of
the front left and right speakers relative to the
listening position. Ideally, the front left and right
speakers should be equidistant from the listening
position and at an angle close to one of the two
available settings.
Front left speaker Front right speaker
Listening angle: 30°
Note
• For best results, we recommend setting "
and "Wide" to 40°.
LFE Level
■
Dolby Digital , DTS , Multich PCM, Dolby
*1 *2
TrueHD, DTS-HD Master Audio, DSD
– dB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE
(Low Frequency Effects) channel individually for each
input sources.
If you find that low-frequency effects are too loud
when using one of these sources, change the setting
to –20 dB or – dB.
*1 Dolby Digital and Dolby Digital Plus sources
En-68
*2 DTS and DTS-HD High Resolution sources
*3 DSD (Super Audio CD) sources

4. Source Setup

Items can be set individually for each input selector.
Press the input selector buttons to select an input
source.
Audyssey ®
The tone for each speaker is set automatically by
Audyssey MultEQ
Setup. To enable the following settings, you must first
perform the Room Correction and Speaker Setup
(➔ page 27).
• These technologies cannot be used when a pair of
headphones is connected.
■
Audyssey
Off
Movie:
Select this setting for movie material.
The Audyssey indicator will light.
Music:
Select this setting for music material.
Narrow
" to 20°
The Audyssey indicator will light.
Note
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• Audyssey equalizing does not work with DSD sources.
*3
Advanced Operations
® Room Correction and Speaker
Operating
procedure
(➔ page 60)