Channel Level - Denon AVR-1312 Getting Started

Default settings are underlined.
3 Use ui to select a speaker, and use
o p
to select distance.
Front L / Front R / Center / Subwoofer /
Surround L / Surround R / Surround Back Lz /
Surround Back Rz
Select the speaker.
z When the "Speaker Confi g." – "Surround
Back" (vpage 5) setting is
to "None", "Surround Back L" and
"Surround Back R" is not displayed.
• 0.0ft – 60.0ft : Set the distance.
• The speakers that can be selected differ
depending on the "Speaker Confi g."
(vpage 5) settings.
• Default settings :
Front L / Front R / Center / Subwoofer : 12.0 ft
Surround L / Surround R /
Surround Back L / Surround Back R : 10.0 ft
• Set the difference in the distance between the
speakers to less than 20 ft.
NOTE
Speakers set to "None" in "Speaker Confi g."
(vpage 5) are not displayed.
4 Press to enter the setting.
ENTER
Speaker Setup
Speaker Config. Step
Bass Setting Front L/R
Distance Center

Channel Level

Subwoofer
Crossover Freq. Surround L/R
SVENSKA SVENSKA NEDERLANDS NEDERLANDS
Channel Level
1 Use ui to select "Channel Level",
and then press .
ENTER
Speaker Setup
Speaker Config. Test Tone Start
Bass Setting Default
Distance
Channel Level
Crossover Freq.
set
[ENTER] Enter [ ]
Channel Level
1
Test Tone Start
Default
2 Press .
ENTER
Output test tone.
Channel Level
1
Front L 0.0dB
Center 0.0dB
Front R 0.0dB
Surround R 0.0dB
Surround L 0.0dB
Subwoofer 0.0dB
[ENTER] Enter [ ]
ESPAÑOL ESPAÑOL PORTUGUÊS ITALIANO
3 Use ui to select a speaker, and use
o p
to adjust the sound volume of
each speaker to be equal.
Front L / Center / Front R / Surround R /
Surround Back Rz / Surround Back Lz /
Surround L / Subwoofer
Select the speaker.
z When the "Speaker Confi g." – "Surround
Back" (vpage 5)
to "None", "Surround Back L" and
Return
"Surround Back R" is not displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
• When o is pressed while the subwoofer volume
is set to "–12 dB", the "Subwoofer" setting
switches to "OFF".
• When "Channel Level" is adjusted, the adjusted
values are set for all the surround modes. To
adjust the channel level separately for the
different surround modes, use the operation
see vm page 26 "Adjusting the volume of
the speakers".
NOTE
• Speakers set to "None" in the "Speaker Confi g."
(vpage 5) settings are not displayed.
• When a headphones jack is inserted in the
PHONES jack of this unit, the "Channel Level"
is not displayed.
Return The "Channel Level" settings are
Default
returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
FRANÇAIS ESPAÑOL FRANÇAIS DEUTSCH
Default settings are underlined.
4 Press to enter the setting.
ENTER
Channel Level
1
Test Tone Start
Default
RETURN B
5 Press
setting is set
Speaker Setup
Speaker Config.
Bass Setting
Distance
Channel Level
Crossover Freq.
ENGLISH ENGLISH
.
Test Tone Start
Default
7 7