Before You Begin
Using the Camera Connected to a Computer
Getting Started
Using the Camera Connected to a Computer
To start using your camera connected to a
computer, do the following.
"
It is not necessary to turn the computer off.
1
Assemble the camera
2
Install the included DCS Capture Studio, DCS
Camera Manager, and DCS Photo Desk
software. (Follow the instructions on the
software CDs.)
3
Connect the camera to the computer and
power supply
(page
Turn the computer on, if it isn't already.
4
"
The Power button has no effect when the
camera is connected to a computer.
Contents
Back
(page
33).
55).
Next
Start the Capture Studio software or Camera
5
Manager software.
6
Capture images.
7
Review and edit the images, as needed, in the
DCS Capture Studio or DCS Photo Desk
software and save them to the computer's
hard drive in the desired format.
Index
54