Powering Your Camera - Kodak DCS PRO BACK - USER'S GUIDE Manual

Using the Camera Connected to a Computer

Powering Your Camera

When connected to the computer, your camera
receives its power from the included AC adapter
(via the IEEE 1394 interface) or a compatible
battery. If you use an IEEE 1394 cable other than
the one included with your DCS Pro Back Plus,
ensure that it is a 6-wire IEEE 1394 cable (4-wire
cables will not work).
If you do not use the AC adapter with the IEEE
1394 cable, the DCS Pro Back Plus will not
receive enough power. An error message
appears.
Contents
Back
To Power the Camera
With the IEEE 1394 cable and DCS Pro Back
Plus AC Adapter
battery
on.
It takes 5-6 seconds for the DCS Pro Back Plus
to activate once the initial power signal is
received. When ready, the Camera Ready LED
illuminates. (The Power button has no effect
when power is supplied by the IEEE 1394
connection.)
"
To Turn the DCS Pro Back Plus Off
Disconnect the IEEE 1394 cable.
Next
Index
(page 55)
(page 61) connected, turn the computer
If you turn the Image LCD on, it turns off
automatically after the time specified in the
Display Off Time property
or a compatible
(page 51).
59