Table of Contents
Advertisement
Correcting Problems
(A) Heater Line
4–10
6. Rub the cloth back and forth along the entire length of the printhead's
heater line which is shown in area A of the following diagram.
(Bead)
Clean this area
only, along entire
length of Heater
Line. Do not clean
or wipe below this
area, as damage to
the Thermal Head
could result.
(C) Circuit Cover
The heater line (A) aligns with the center (filled) slot on the backing
plate (B). Be careful not to rub the sealant which protrudes from
beneath the circuit cover (C) as damage to the printhead could occur.
Center (filled) slot
aligns with Heater Line
when viewed from front.
(B) Backing Plate
Circuit Board
Thermal Print Head
Sealant Protecting
Circuit Row
DO NOT VIOLATE
January 1998
Advertisement
Table of Contents
