Correcting Problems
4–6
Symptom
Multicolored spots appear
on prints.
Printer initializes, but does not
enter the READY state.
Paper will not feed.
Possible solution(s)
D
Clean the printer and the area
around it.
D
Move printer away from
ventilation ducts or open doors.
D
Disconnect and reconnect the
interface cable to the printer.
D
Restart the printer. If the
problem persists, service
is required.
D
Look at the paper and
remove any from the stack
that have irregularities.
D
Reduce the size of the stack of
paper in the paper tray.
D
Make sure that the blue stiffener
sheet is at the bottom of the
paper tray.
January 1998