Table of Contents
Advertisement
January 1998
Symptom
No printer response when
buttons are pressed.
Display panel says CHANGE
RIBBON, but the correct ribbon
is loaded and the supply spool is
not empty.
Display panel says CHECK
TRAY, but tray is not empty.
Display panel says LOAD
RIBBON, but ribbon is already
loaded.
Dirt appears on prints.
Correcting Problems
Possible solution(s)
You may have pressed invalid
buttons.
1. Make sure the printer cover is
closed.
2. Reinsert the paper tray.
3. Restart the printer.
4. Make sure the printer is in
READY mode.
D
Open the printer cover and
check to see if the barcode on
the ribbon is legible.
D
Check to see if the ribbon
is jammed.
D
Open the printer cover, remove
tray, and inspect for paper jam.
The requested ribbon is not
loaded in the printer.
D
Open the printer cover and load
the requested ribbon.
D
Make a test print to clean out
remaining debris.
D
Clean the thermal head per the
instructions in Getting Started. If
streaks persist, use the
alternate procedure described
in this chapter.
4–7
Advertisement
Table of Contents
