Table of Contents
Advertisement
4. To clean the print head, first use the water pad and then use the
alcohol pad. With each pad, wipe along the heater line four times as
follows:
—Wipe the full length of the glass area (always in one direction).
—Use a clean part of the pad for each wipe.
—Apply firm, even pressure.
—Wipe the metal roller bar and rod as shown.
5. Allow the glass area to dry for about two minutes.
6. Do one of the following:
If reloading the ribbon , load the supply spool first (with the bar code
on the left. If the ribbon gets dirty or is damaged, wind the take-up
spool ahead to the next clean magenta section.
If loading a new ribbon , refer to the instructions on the ribbon
package.
7. Close the printer cover, and turn the printer On .
October 1997
AVOID METAL
EDGE!
Setting up the printer
Metal roller bar
Metal bar
Header line
Rod
2-7
Advertisement
Table of Contents
