Oc Tweaker Screen - ASROCK VISION 3D SERIES User Manual

9.3 9.3 OC T 9.3 OC T OC Tweak OC T weak weaker Screen weak er Screen er Screen er Screen
9.3 9.3 OC T weak er Screen
In the OC Tweaker screen, you can set up overclocking features.
Main OC Tweaker
OC Tweaker Settings
Load CPU EZ OC Setting
Load Memory EZ OC Setting
CPU EZ OC Setting : 3.0GHz
Overclock Mode
BCLK Frequency (MHZ)
Boot Failure Guard
Boot Failure Guard Count
Spread Spectrum
CPU Ratio Setting
QPI Frequency
DRAM Frequency
DRAM Timing Control
VCORE Voltage
VCCM(DRAM) Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Load CPU EZ OC Setting
You can use this option to load CPU EZ overclocking setting. Please note
that overclocing may cause damage to your CPU and motherboard. It
should be done at your own risk and expense.
Load Memory EZ OC Setting
You can use this option to load memory EZ overclocking setting. Please
note that overclocing may cause damage to your memory module and
motherboard. It should be done at your own risk and expense.
Overclock Mode
Use this to select Overclock Mode. Configuration options: [Auto], [Manual]
and [Optimized]. The default value is [Auto].
BCLK Frequency (MHz)
Use this option to adjust BCLK (Internal Base Clock) frequency.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Boot Failure Guard Count
Enable or disable the feature of Boot Failure Guard Count.
Spread Spectrum
This item should always be [Auto] for better system stability.
CPU Ratio Setting
If the ratio status is unlocked, you will find this item appear to allow you
changing the ratio value of this motherboard.
QPI Frequency
Use this option to adjust QPI (QuickPath Interconnect) frequency. Configu-
ration options: [Auto], [3.200GT], [3.733GT], [4.266GT] and [4.800GT]. The
default value is [Auto].
3 6 3 6 3 6
3 6 3 6
BIOS SETUP UTILITY
Advanced H/W Monitor Boot
Overclocking may cause
[Press Enter]
damage to your CPU and
[Press Enter]
motherboard.
It should be done at
your own risk and
[Auto]
expense.
[167]
[Enabled]
[3]
[Auto]
[Auto]
[Auto]
Enter Go to Sub Screen
[Auto]
F1
F9
F10
[Auto]
ESC
[Auto]
Security Exit
Select Screen
Select Item
General Help
Load Defaults
Save and Exit
Exit