Run-Mode Measurement Process - Omron ZFX - SHORT MANUAL V1.0 Manual

Smart sensor vision sensor with built-in touch screen

Hide thumbs

Table Of Contents

Table of Contents

TRIG Measurement-Mode

TRIG

How to input

Continuous Measurement Command and Stop Command

How to input

There are two measurement-mode. In TRIG measurement-mode, TRIG is the

first event and one measurement is done. In continuous measurement-mode,

continuous measurement command is the first event and measurements are

done repeatedly until stop command.

TRIG

Measurement

Result output

Wait for next TRIG

1. Serial Command via RS-232C/422, USB, Ethernet

It's needed to send the command from external device (e.g. PC, PLC)

Please see the detail in "Serial Communication Command Reference"

2. Parallel (TRIG Signal)

One measurement is done if TRIG signal is turn ON.

1. Serial Command via RS-232C/422, USB, Ethernet

It's needed to send the command from external device (e.g. PC, PLC)

Please see the detail in "Serial Communication Command Reference"

2. Parallel Communication

• Continuous Measurement Command

It's needed to send the command from external device (e.g. PLC)

Please see the detail in "User's manual"

During continuous measurement, it's needed to keep the state of input

command.

• Stop Command (Stop condition)

If the status of continuous measurement command breaks, continuous

measurement is ended.