Table of Contents
Advertisement
Terminal Block Errors
Problem
Trigger signals (input
The cables are not wired correctly.
signals) are not received.
The signal line is disconnected.
The Controller is not in the Run mode.
Signals cannot be output
The trigger signal has not been input.
externally.
The cables are not wired correctly.
The signal line is disconnected.
The Controller is not in the Run mode.
RS-232C Communication Errors
Problem
No communication is
The cables are not wired correctly.
possible.
The communication specifications of the Controller do not match
those of the external device.
The Controller is not in the Run mode.
The unit operates well
The buffers on the receiving side (PC) are full. Check wheter
initially, but after a while
they are set to receive data properly.
there is no response
from the Controller.
Probable cause
Probable cause
SECTION 4
Appendix
Reference
p.30
p.30
Reference
p.34
-
43
Setup Manual
Advertisement
Table of Contents
