Omron Z5FP-MC10 Setup Manual page 10

INTRODUCTION
Please observe the following precautions for safe use of the products.
Installation Environment
• Do not use the product in environments where it can be exposed to inflammable/explosive gas.
• Do not install the product close to high-voltage devices and power devices in order to secure
the safety of operation and maintenance.
Power Supply and Wiring
• Make sure to use the product with the power supply voltage specified by this manual.
• Make sure to use crimp terminals when performing the wiring of the product. Do not simply
connect the twisted ends of the wires directly to the terminal block.
• Use a power supply cable and crimp terminals of the specified size.
• Check carefully that the wiring is correct before turning the power supply on.
• Make sure to install the terminal block protection cover after wiring.
• Use a DC power supply with safety measures against high-voltage spikes (safety extra low-
voltage circuits on the secondary side) for the power supply to the terminal blocks of the
Controller.
p.20
• Make sure to tighten all installation screws securely.
Other
• Do not disassemble, repair, or modify the product.
• Dispose of this product as industrial waste.
8
Setup Manual
Precautions for Safe Use