Omron Z5FP-MC10 Setup Manual page 37

Wiring
The maximum cable length is 15 m.
Standard
Controller
Signal Pin No.
SD(TXD) 2
3
RD(RXD)
4
RS(RTS)
5
CS(CTS)
9
SG(GND)
Wiring for RS/CS Control
Controller
Signal Pin No.
SD(TXD) 2
RD(RXD) 3
RS(RTS) 4
5
CS(CTS)
SG(GND) 9
*Pin numbers on the external device will depend on the device being connected.
Refer to the manual for the personal computer or PLC being connected.
Connection Method
Align the connector with the socket and press it straight into place, then fix it with the screws on
both sides of the connector.
•
Turn the power supply off when connecting or disconnecting a cable. Failure to do so may cause
damage to peripheral devices.
•
Always tighten the connector screws securely.
External device
Pin No.
*
*
*
*
*
Use a shielded cable.
External device
Pin No.
*
*
*
*
*
Use a shielded cable.
SECTION 3
Connecting External Devices
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
Setup Manual
35