Table of Contents
Advertisement
3-2 Antenna
3-2-1 Installation Site
♦ Installation site
Do not install the antenna at any place below:
• Place where the ambient temperature is out of the range between -10 and +70°C, where the temperature fluctuates considerably and
where condensation occurs.
• Place where the relative humidity is out of the range between 35 and 85%RH.
• Place where there is corrosive gas, flammable gas, dust, salt or iron powder.
• Place affected by vibration or impact.
• Place splashed with water, oil or chemicals
When you install the antenna, be sure to follow the instructions above and test it fully.
In addition, on both inside and outside of the control panel, lay the antenna cables separately from the power cables.
3-2-2 How to Install
♦ Model V670-H11
• Installation on a surface
• Installation on the back
Insert a nut which comes with the antenna into the section A.
3-16
Note
M4 screw
(Tightening torque: 1.2 N•m or less)
M4 nut
M4 screw
(Tightening torque: 1.2 N•m or less)
28±0.2
27±0.2
(Unit: mm)
2-M4
47
A
28±0.2
27±0.2
47
(Unit: mm)
Advertisement
Table of Contents
