Table of Contents
Advertisement
3-1-3 How to Install
The controller can be installed in a panel with screws or on a DIN rail.
♦ Installation in a panel
If you install the controller in a panel, be sure to use spring washers, flat washers and M4 screws. (Tightening torque: 1.2 N•m or less)
Do not use any organic solvent such as lock paint to fix screws. Otherwise, the case may crack.
♦ Installation on a DIN rail
Support Rail
Model PFP-100N2
Recommendable DIN rail
Model PFP-100N2 (Rail
length 1 m)
(OMRON)
V 6 7 0 - C D 1 D
DIN Rail
V670-CD1D
ID
End Plate
Hook
(Unit: mm)
• When you install the controller on the DIN rail, hook the
controller over the A and push the controller in the direc-
tion B.
• When you remove the controller from the DIN rail, pull
the hook downward and remove the controller pushing
slightly upward.
MAX.90
End Plate
Model PFP-M
3-1 Controller
(Unit: mm)
3-7
Advertisement
Table of Contents
