System Configuration - Omron V640 - MANUAL 2 User Manual

SECTION 1
Product Outline

System Configuration

When SECS Is Used
Communication with the host device is possible using the SECS protocol.
Host
This is e.g. a host,
or equipment con-
troller.
When SECS Is Not Used
Communications with the host device follow the OMRON proprietary protocol.
The Amplifier Units are connected directly to the host device without using a CIDRW Controller.
Host
This is e.g. a host,
or equipment con-
troller.
Refer to the following page for specific connection examples.
Using Link Units (V700-L11) to make connections makes it possible to remove and replace just the relevant
Amplifier Unit while leaving the power to the CIDRW system on in the event of a failure or during mainte-
nance.
CIDRW System
18
User's Manual
CIDRW Controller
V700-L22
RS-232C
SECS I/II
Multiple Amplifier Units
are controlled in
response to commands
(SECS) from the host
device.
RS-232C
OMRON proprietary protocol
page 108
Amplifier Unit
V640-HAM11-V2
RS-232C
These are units that
control a CIDRW Head.
Amplifier Unit
V640-HAM11-V2
These are units that
control a CIDRW Head.
CIDRW Head
V640-HS61
These are antennae for
reading the carrier IDs
from the ID Tags and
writing the carrier IDs.
CIDRW Head
V640-HS61
These are antennae for
reading the carrier IDs
from the ID Tags and
writing the carrier IDs.