How To Use This Manual - Omron V400-H111 User Manual

How to Use This Manual

Page Format
Creating Setting Files Using the 2DCR Configear
Creates the data setting file for loading set data to the Handheld 2D Code Reader.
Make the settings for the communications conditions, functions, and display conversion.
Se lect Setting Reader - Create Data... from the menu.
The following window for creating the setting data file will be displayed.
■ Open
Opens the previously created data setting file for editing.
The [Receive (R)] function can be used to open the data file downloaded from the Code
Reader and edit it.
■ Save
Saves the created data setting file.
To save data to the Memory Card, create a folder with the name SETTINGS, and save. If the data is
saved to a folder other than "SETTINGS", it cannot be uploaded.
Communication Settings
The settings shown in the following table are set in the Communication Settings Tab
Page in the Create Setting Data Window.
Setting item
* , 19,200, or 38,400
Baud Rate 9,600
* , odd, or even
None
Parity
Data Length
77 bits or
* or 2 bits
Stop Bit 1sbit
None*
Header/Footer Prefix
, 02 <STX>, or 1B <ESC>
Suffix
ETX, 0A LF,
FCS OFF
ON or
The default settings are indicated with an asterisk.
Procedure and additional explanations
Information useful during the operation and reference pages
are provided here with special marks to indicate the kind of
information being provided.
Section 4
System Settings
Settings
*
8 bits
*
0D CR
, or 0D0A CR+LF
*
V400-H111/211
User's Manual
Section title
Section 4
System Settings
Outline
Move to the setting screen.
Screen display
Index label
Provides the section number
and subject matter. Can be
used to immediately open the
desired page.
Describes the settings.
65
V400-H111/211
69
User's Manual
*This page does not actually exist in this manual.
Introduction
V400-H111/211
7
User's Manual