Omron V400-H111 User Manual page 25

Connecting Cables to the Handheld 2D Code Reader
Connect one end of the cable to a personal computer or Programmable Controller before
connecting the other end of the cable to the Handheld 2D Code Reader.
1.
Attach the provided ferrite cores to the cable.
Attach the ferrite cores in two locations; one at the Handheld 2D Code Reader end of the cable, and the other
at the host device end of the cable.
Close the ferrite cores until a click is heard. Separate from the power lines.
2.
Remove the cover from the Code Reader.
Loosen the four screws to detach the cover.
Ferrite cores
Section 2
Installation and Connections
V400-H111/211
23
User's Manual