Selectable Smart Active Parts are shown in the preview box on the right. Title of the selected
Smart Active Parts are shown in the bottom center dialogue box.
Select appropriate Smart Active Parts and click Use.
By doing so, the selected Smart Active Parts is pasted onto the screen that is being edited.
The Smart Active Parts part is pasted onto the upper left corner of the screen. Move to the
desired location.
Or, click the Smart Active Parts part and set communications parameters.
port to which command
is
sent
Destination Unit No.
SerialA :when connected to serial port A
SerialB :when connected to serial port B
0 to
:Communications
31
temperature
controller you want to operate.
With broadcast to all parts, this parameter
is not used. Keep default value 0.
unit
No.
of
the
15