Connection Example - Omron G3PW - MANUAL 2 User Manual

Communications Settings
Example: Setting Communications Parameters
6-1-3

Connection Example

Setting the G3PW Communications Unit Numbers to the Same Numbers as the EJ1
Channel Numbers
Setting Example
1,2,3...
68
Display the initial settings mode screen, and then use the Up and Down Keys
p01
to display p19 (the parameter for which the setting is to be changed in this
example).
When the ENT/RST Key is pressed, the present set value for
the selected parameter will be displayed.
ENT
RST
p19
ENT
RST
Press the ENT/RST Key to enter the new setting. The data display will
stop flashing, and the parameter display will return.
An EJ1 TC4 Unit has four channels. It can thus be connected to up to four
G3PW Power Controllers.
1. The G3PW communications unit numbers [P19] can be set to the same
numbers as the EJ1 channel numbers, as shown below.
26
Use the Up and Down Keys to set a new value.
The data display will flash.
20
Section 6-1