Table of Contents
Advertisement
Nomenclature
Movable Plunger
Rubber Cap (NBR)
Rubber cap provides a tight seal and
ensures a long service life and
smooth reset at low temperatures.
Seal Packing (NBR)
Seal packing withstands a pressure of
186 kPa (D4E's seal packing with-
stands a pressure of 98 kPa).
Terminal Protection Cover
D4E-@N has a wide wiring space of
10 mm horizontally (D4E has a space
of 7.5 mm horizontally).
F-36
Small Sealed Switch
Screw Terminal
Screw terminal incorporates a M3
screw with a toothed washer.
D4E-@
N
Bearing
The actuator strength has been increased to 4,903 N
(D4E: 294 N) in order to prevent faulty resetting of
the bearing, which may occur when the roller is
pressed with excessive force.
Built-in Switch
Switch cover ensures high insulation between the
terminals and die-cast. Double insulation means that
grounding is unnecessary. Meets UL, CSA, and EN
standards.
Prevents the movable piece from being pushed in
too far, and thereby contributes to a longer service
life.
Die-cast Case
Zinc die-cast case is anti-corrosive and tough.
Wiring Ease
Wired made easier using (D4CC-type)
plug-in connector.
Advertisement
Table of Contents
