Operation Procedure; Section 2 - Omron CX-MOTION-NCF - V1.9 Operation Manual

Operation Procedure

1-4

Operation Procedure

Connecting to Built-in RS-232C port on
CPU Unit
Adding Position Control Unit to Project
Adding Servo Drive to Position Control Unit
Position Control Unit Positioning Operation
6
The outline of the procedures required to install the CX-Motion-NCF and CX-
Server, create various data, transfer it to Position Control Units, and use in
actual operations is shown below.
Installing CX-Server
Installing CX-Motion-NCF
Starting CX-Motion-NCF
Creating a New Project
Starting Axis Map Setting Window
Editing/Transferring Unit
Parameters/Servo Parameters
Writing to Flash Memory
Monitoring
Quitting Axis Map Setting Window
Saving Project
Quitting CX-Motion-NCF
Refer to section 2-1.
Refer to section 2-1.
Refer to section 2-2.
Refer to section 3-2.
Refer to section 4-1.
Refer to section 4-2.
Refer to section 3-2.
Refer to section 4-3.
Refer to sections 5-1, 5-2, 7-3, and 7-4.
Refer to section 7-6.
Refer to the Position Control
Unit's operation manual.
Refer to SECTION 8.
Refer to section 3-2.
Refer to section 6-1.
Refer to section 3-2.
Section 1-4