Installing And Uninstalling The Software; Connecting To Plc - Omron CX-MOTION-NCF - V1.9 Operation Manual

Installing and Uninstalling the Software

2-1 Installing and Uninstalling the Software
2-1-1 Software That Must Be Installed
1,2,3...
Installing of CX-Motion-
NCF
2-2

Connecting to PLC

2-2-1 Connecting to CS/CJ-series PLCs
Connection Format
Personal
computer
IBM PC/AT
or compati-
ble
Note
8
The following software must be installed on the same computer to use the CX-
Motion-NCF.
1. CX-Motion-NCF
2. CX-Server (the communications driver)
Refer to the CX-One Ver. 3.0 Setup Manual (Cat. No. W463) (supplied with
the CX-One FA Integrated Tool Package) for information on how to install or
uninstall the CX-Motion-NCF from the CX-One FA Integrated Tool Package.
Cat. No. Model
W463 CXONE-AL@@C-V3/
CXONE-AL@@D-V3
To transfer the project data that was created using CX-Motion-NCF to the
Position Control Unit. The personal computer and PLC (CPU Unit) must be
physically connected with a cable and also connected online.
Using either the Host Link (SYSMAC WAY) or Toolbus, connect the personal
computer to the peripheral port or RS-232C port on the PLC.
Connecting to Peripheral Port
9-pin
male
9-pin
female
Peripheral port
(10-pin female)
CS1W-CN118 (0.1 m) (See note.)
CS1W-CN226 (2.0 m)
CS1W-CN626 (6.0 m)
(See note.)
CS1W-CN118
CS1W-CN226
CS1W-CN626
9-pin
female
The cable model CS1W-CN118 is used as a relay cable to connect the per-
sonal computer to the CPU Unit's peripheral port using the RS-232C cable
(model XW2Z-@@@@-@@) as shown below.
RS-232C Cable
Manual name
CX-One Ver. 3.0 An overview of the CX-One
Setup Manual FA Integrated Tool Package
and the CX-One installation
procedure
Connecting to RS-232C Port
9-pin
male
XW2Z-200S-CV / 200S-V (2.0 m)
XW2Z-500S-CV / 500S-V (5.0 m)
XW2Z-200S-CV / -200S-V
XW2Z-500S-CV / -500S-V
10-pin
Peripheral Port
CS1W-CN118
Section 2-1
Contents
9-pin
male
RS-232C port
9-pin
(9-pin female)
female
9-pin 9-pin
female male