Operation Procedure
1-4
Operation Procedure
Installing CX-Motion-MCH
Installing CX-Server
Connecting to Built-in RS-232C port on
CPU Unit
Starting CX-Motion-MCH
Creating a New Project
Adding MC Unit to Project
Adding Tasks, Axes, Programs,
and CAM Data to MC Unit
Editing/Transferring MC Unit's System
Parameters, Servo Parameters, Position
Data, Programs, and CAM Data
Writing to Flash Memory
MC Unit Monitoring
Saving Project
Quitting CX-Motion-MCH
6
The following flowchart shows the procedures required to install CX-Motion-
MCH and CX-Server, create various data, transfer that data to MC Units, and
use in actual operations.
Refer to page 8
Refer to page 8
Refer to page 8
Refer to page 14
Refer to page 30
Refer to page 31
Refer to page 33
Refer to SECTION 5 Editing Data and
page 56
Refer to page 60
Refer to SECTION 8 Monitoring
Refer to page 44
Refer to page 15
Section 1-4