Table of Contents
Advertisement
Keypad Operation
Digital Operator Display (optional)
The key names and functions of the Digital Operator are described below
Digital Operator Keys
Key
LOCAL/REMOTE Key
MENU Key
ESC Key
JOG Key
FWD/REV Key
Shift/RESET Key
Increment Key
Decrement Key
DATA/ENTER Key
RUN Key
STOP Key
Name
Switches between operation via the Digital Operator (LOCAL) and
the settings in b1-01 and b1-02 (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
Selects the modes.
Returns to the status before the DATA/ENTER Key was pressed.
Enables jog operation when the Inverter is being operated from the
Digital Operator.
Selects the rotation direction of the motor when the Inverter is being
operated from the Digital Operator.
Sets the active digit when programming user parameters.
Also acts as the Reset key when a fault has occurred.
Selects user parameter numbers and increments parameter set-
tings.
Used to move to the next item or data.
Selects user parameter numbers and decrements parameter set-
tings.
Used to move to the previous item or data.
Enters menus and parameters and validates parameter settings.
Starts operation when the Inverter is being controlled by the Digital
Operator (LOCAL Mode).
Stops Inverter operation (LOCAL and REMOTE Mode).
This key can be enabled or disabled when operating from a source
Drive Mode Indicators
FWD:
Lights up when a forward run command is
input.
REV:
Lights up when a reverse run command is
input.
SEQ:
Lights up when the run command from the
control circuit terminal is enabled.
REF:
Lights up when the frequency reference from
control circuit terminals A1 and A2 is enabled.
ALARM: Lights up when an error or alarm has
occurred.
Data Display
Displays monitor data, parameter numbers, and set-
tings.
Mode Display
DRIVE: Lights up in Drive Mode.
QUICK: Lights up in Quick Programming Mode.
ADV:
Lights up in Advanced Programming Mode.
VERIFY:Lights up in Verify Mode.
A. TUNE:Lights up in Autotuning Mode.
Keys
Execute operations such as setting user parameters,
monitoring, jogging, and autotuning.
Function
EN-14
Advertisement
Table of Contents
