Special Safety Advice Relating To Grinding And Disc-Cutting; Special Safety Advice For Abrading Using Sandpaper; Special Safety Advice For Polishing - Parkside PFBS 9.6 V - MANUAL 6 Manual

© Special safety advice relating
to grinding and disc-cutting
Always use the guard designed for
the type of abrasive consumable you
are using.
Abrasive consumables must be used
only for their recommended purpos-
es, For example: never grind with the
side face of a cutting disc.
Always use an undamaged mounting
flange of the correct size and shape
for your selected grinding disc.
Never use worn down abrasive con-
sumables intended for larger electrical
power tools.
© Further special safety
advice for disc-cutting
Avoid snagging the cutting disc and
do not use too much contact pressure.
Do not attempt to make excessively
deep cuts.
Avoid the area in front of or behind
the rotating cutting disc.
If the cutting disc jams or you stop
work for a while, switch the device
off and hold it until the disc comes to
a complete stop. Never attempt to
pull the still rotating cutting disc out of
the cut as this could cause kickback.
Do not switch on the device if the cut-
ting disc is in the workpiece.
Support boards or workpieces whilst
cutting to reduce the risk of kickback
caused by a jammed cutting disc.
Be particularly careful when pocket
cutting in existing walls or other areas
where you cannot see what you are
cutting into.
©
Special safety advice for
abrading using sandpaper
½
Do not use over-sized sanding sheets.
Follow the manufacturer's recommen-
dations for sanding sheet size.
©
Special safety
advice for polishing
½
Do not use the polishing bonnet if it
has any loose parts, in particular the
fastening cords.