Operation; Setting The Speed; Fitting The Sanding Sheets; Dust Extraction - Parkside KH 3123 PLANSLIP Manual

4 manual GB (+IRL)_Helv
+ www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++

OPERATION

Take note of the mains voltage. The voltage must agree with that shown on the identification plate (equipment
shown as 230 V can also be used with 220 V).
SWITCHING ON AND OFF
SWITCH ON SANDER
SWITCH OFF SANDER

SETTING THE SPEED

You can set the required speed using the adjuster wheel
what kind of material you are working with, use the recommendations and examples given in Tips and Tricks.

FITTING THE SANDING SHEETS

Note: before fitting a new sanding sheet, remove dust and dirt from the base .
1. Lift both clips
use on a different material.
2. Push the sanding sheet
moving the clip down again.
3. Do the same at the other end. Make sure that the sanding sheet
4. Important! - The holes in the sanding sheet
base. See Figure .
Different materials need different grades of sanding sheets. To determine which grade is suitable for your work,
please read our recommendation in Tips and Tricks.

DUST EXTRACTION

• DUST EXTRACTION WITH PAPER DUST BAG
Push the paper dust bag
Clip the dust bag with the adapter to the side of the sander.
• DUST EXTRACTION WITH VACUUM CLEANER
For dust extraction using a vacuum cleaner use the appropriate connector – see Figure . Attach the adapter to
the end of the vacuum cleaner hose and clip it to the side of the equipment.
MAINTENANCE OF THE ORBITAL SANDER
1. Clean the sander regularly. For the best results do this straight after the work has been completed.
2. Do not allow liquids to get inside the sander. Use a soft cloth for cleaning the housing. Do not use petrol,
solvents or cleaners that may attack the plastic.
3. Air vents must always be clear and clean.
17.06.2003
= press switch
= press switch
to open them to insert a new sanding sheet or change the sanding sheet for
under the open clip at one end and clamp it securely on the base by
and the base
on to the adapter . Ensure that the adapter fits correctly into the holder.
14:21 Uhr Seite 5
again
(see Fig ) as required. As the setting depends on
is tight against the base. See Figures
must align for the dust to be extracted through the
5
and .