Original Accessories/Auxiliary Equipment; Operation; Switching On And Off; Fitting The Sanding Sheet - Parkside 427539 2301 Original Instructions Manual

WARNING! RISKS DUE TO DUST!
► When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate
external dust extraction appliance. Wear
safety goggles and a protective dust mask!
■ Provide sufficient ventilation when working
on plastics, paints, lacquers, etc.
■ Do not soak the materials or the area to be
processed with liquids containing solvents.
■ Avoid sanding lead paint or other harmful
materials.
■ Materials containing asbestos must not be
processed.Asbestos is a known carcinogen.
■
The device is designed for the dry surface
sanding of wood, plastic, metal and plaster
and painted surfaces.
■ Never work on moistened materials or damp
surfaces. Water entering a power tool will
increase the risk of electric shock.
■ Always hold the appliance firmly with two
hands while working.
■ Do not rest your hands next to or in front of
the appliance and the area being worked as
there is a risk of injury if you slip.
■ Always switch the appliance off and allow
the sanding sheet 7 to stop oscillating before
putting the appliance down.
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance (e.g. changing the sanding
sheet) and when it is no longer in use.
■ The appliance must always be kept clean, dry
and free from oil or grease.
Original accessories/auxiliary
equipment
■
Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.
PPS 200 C2

Operation

Switching on and off
Switching on
♦ Press the ON/OFF switch 0 to position "I".
Switching off
♦ Press the ON/OFF switch 0 to position "0".

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
Before fitting a new sanding sheet 7, remove
►
any dust and dirt from the sanding plate 6,
8 and 9.
► Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
Position the sanding sheet 7 flush on one side
♦
of the sanding pad 6, 8 and 9.
Then place the sanding sheet 7 on the sanding
♦
pad 6, 8 and 9 and press it firmly into
place.
Different materials require different grain sizes.
You can find out which grain is suitable for which
work in our non-binding recommendations in
"Work instructions, tips and tricks".
GB │ IE │
5 ■