Connecting First-Time Wireless Clients - THOMSON SPEED TOUCH 585 User Manual

Chapter 2
Local Network Setup

2.2.2 Connecting First-time Wireless Clients

Wireless default
Preparing first-time
wireless clients
Configuring first-time
wireless clients
First-time association
24
After every Reset-to-Defaults, the SpeedTouch™ wireless access point configuration
settings is returned to its initial default settings.
These default settings are:
Security level is low (security disabled) for an easy first use, meaning the data
will not be encrypted. Wireless security settings are described in
"2.2.3 Wireless Security" on page
The SpeedTouch™ is broadcasting its network name (SSID).
This default network name (SSID) is printed on the identification label located
on the bottom of your SpeedTouch™ and is unique for each device. It consists
of the concatenation of the word "SpeedTouch" and 6 hexadecimal characters,
without any spaces, for example SpeedTouch123456.
The radio channel number is set to 'automatically scan for the best radio
channel'.
Registration is not activated. New stations are allowed automatically. The
Access Control List is open and empty. No wireless client will be denied access
to the SpeedTouch™ based on its physical hardware address.
The default wireless settings may differ from the settings listed above
depending on your Service Provider's requirements. If this is the case, refer
to the installation/configuration instructions provided by your Service
Provider.
Make sure that:
The SpeedTouch™ is powered on and ready for service.
The SpeedTouch™ is in its default configuration.
If needed, reset the SpeedTouch™ to its default configuration (See
to Factory Defaults" on page 110
A wireless client adapter is installed on your computer.
The wireless client adapter's IP configuration is set to dynamically obtain its IP
configuration (DHCP) - this is usually the default. For more information, see the
documentation of your wireless client adapter.
The wireless client must be correctly configured for the default network name. As
the SpeedTouch™ broadcasts its network name to the wireless clients, you can select
the SpeedTouch™ wireless network from a list of available networks. Depending on
your wireless client a wireless icon may become green or a message similar to the
following may pop up: "Successfully joined Wireless network SpeedTouch123456".
Some wireless clients do not automatically join a wireless network. If so,
follow the instructions for the wireless client software to initiate association.
In the example below is shown how the SpeedTouch™ wireless network is presented
example towards an MS Windows XP Service Pack 2 system:
27.
for more information).
E-DOC-CTC-20050429-0103 v2.0
"6.3 Reset