Table of Contents
Advertisement
Chapter 6
Troubleshooting
SpeedTouch™ does not
SpeedTouch™
unreachable
Poor SpeedTouch™
performance
104
6.1 General SpeedTouch™ Troubleshooting
If none of the LEDs light up, make sure that:
work
The SpeedTouch™ is plugged into a power socket outlet.
You are using the correct power supply for your SpeedTouch™ device.
The power requirements for your SpeedTouch™ are clearly indicated on
the identification label attached at the SpeedTouch™ bottom.
The power on the SpeedTouch™ is turned on via the push button on the back
panel.
In case your SpeedTouch™ is unreachable due to misconfiguration, you might
consider a hardware reset to factory defaults as described in
Defaults" on page
However, note that resetting the SpeedTouch™ to its factory settings will
!
revoke all the changes you made to the configuration.
Make sure that the SpeedTouch™ is installed and configured as instructed in the
Installation and Setup Guide or as instructed by the Service Provider.
110.
"6.3 Reset to Factory
E-DOC-CTC-20050429-0103 v2.0
Advertisement
Table of Contents
Troubleshooting
