Table of Contents
Advertisement
10.ADAPTATION TO DIFFERENT TYPES OF GAS
Before carrying out the following operations, disconnect the appliance from the
power supply.
The cooker hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. If
other types of gas are to be used, the nozzles must be replaced and the primary
air must be adjusted.
In order to replace the nozzles and adjust the burners, the hob top must be
removed as described below.
10.1 Removing the hob top
•
Remove all the burner components, following the numerical sequence in the
figures below:
•
Take out all the knobs by pulling
them upwards.
•
Lift all the burner components off
the hob.
•
Remove the fastening plates from
each burner by unscrewing the two
screws.
•
Remove the hob fastening screws,
taking care to remove only the
screws shown in the figure to the
side.
•
Having
components described above, lift
the hob top upwards.
50
Instructions for the installer
removed
all
the
Advertisement
Table of Contents
