Installation / Factory Setting; Time Offset - Philips DSR1010 Manual

4.4 INSTALLATION / FACTORY SETTING

After entering the following number combination in the «change PIN» menu, you can reset
changes to the unit settings and restore your unit to its delivery condition (factory setting).
To do this select the «change PIN» menu Key M > Channels > Minor Protection > PIN
1. Enter the current PIN:
or:
2. Enter the following PIN:
3. Enter the following PIN:
All unit settings are reset to the default factory settings:
PIN (protection code): . . . . . . . . . . . . . . . .

Time offset: . . . . . . . . . . . . . . . . . . . . . . .

Menu language: . . . . . . . . . . . . . . . . . . . .
Signal paths: TV SCART . . . . . . . . . . .
VCR Scart . . . . . . . . . . .
TV -> VCR . . . . . . . . . . .
VCR signal . . . . . . . . . . .
Picture format . . . . . . . .
VCR record . . . . . . . . . .
Digital audio . . . . . . . . . .
LNB LNB . . . . . . . . . . . . . . . .
In standby . . . . . . . . . . .
DiSEqC 22kHz signal . . . . . . . . .
Tone burst . . . . . . . . . . .
DiSEqC . . . . . . . . . . . . .
DiSEqC repeat . . . . . . . .
Satellites: Enabling ASTRA . . . . . .
Enabling HOTBIRD . . . .
LO1 . . . . . . . . . . . . . . . .
LO2 . . . . . . . . . . . . . . . .
Orbit pos. ASTRA . . . . . .
Orbit pos. HOTBIRD . . . .
Uncom. switch . . . . . . . .
Names of the favourite lists . . . . . . . . . . . .
N.B.:
Check that the time offset is correct and change the menu language as required.
Please note that any changed PIN is also set to 00000.
4.4.1 Time offset
After switching on at the mains switch or after a power cut the time and date for the system clock
(timer) are transferred from the data received. To ensure that the time and date of the receiver
correspond to local time, a value for the deviation from standard time must be entered.
The offset value for CET summer time is {+2} hours, for CET winter time {+1} hour.
Please check or, if need be, correct the time offset value when setting up your equipment
and also when the time changes in spring and autumn.
Select using key 1 or using the 9 8 keys, then activate using the OK key and set the
(1)
desired time offset value using the * + keys. Confirm the modifications using the OK
key.
N.B.: If an incorrect time offset value is entered, programme times will be indicated
incorrectly.
X X X X X = the PIN changed by you
0 0 0 0 0 = delivery condition
1 1 1 1 1
9 9 9 9 9
0 0 0 0 0
+1h or +2h, according to date of manufacture
German
RGB
CVBS
ON
RGB/CVBS
4 : 3
Standard
Standard
ON
OFF
High/Low
OFF
ON
OFF
ON
ON
9750 MHz
10600 MHz
1
2
OFF
according to delivery condition