Table of Contents
Advertisement
Signal Meter
Channel Searching
Decoder Status Submenu
Factory Reset
18 M A I N M E N U
6.7.3 Signal meter
Signal Meter is used to display the strength and quality
of the signal broadcast at the specified frequency in order
to check your antenna connection and setup.
6.7.4 Channel Search
Channel Search is used to either Search for New
Channels or Reinstall All Channels (your channel list
will be replaced by a new one).
Press OK to launch the channel search. You may
interrupt this procedure by pressing BACK.
6.7.5 Decoder Status
Decoder Status provides information about the system,
loader, and smart card.
Besides, the Decoder Upgrade item is used to check
whether new software is available for your receiver. If
available, press OK to initiate the upgrade. Do not
interrupt this operation once started.
6.7.6 Factory Reset
Set Restore Settings to Yes, and then press OK to
restore the factory settings of the receiver and restart the
first-time installation process. As a result, your channel list
will be replaced by a new one.
6.8 Help
This submenu is used to provide information on how to
use your receiver and set the various settings.
Advertisement
Table of Contents
