Table of Contents
Advertisement
Operation
Switch-on/switch-off
Switch the receiver on by pressing the ON/OFF button
(standby button) on the remote control and wait until you
see the welcome image on your screen.
The LED is green if the receiver is switched on.
When you switch on your receiver for the first time, an
assistant will guide you through all the required steps.
The selection is effected by using the respective arrow
buttons and the OK button.
Initial installation
After the first switch-on, you'll receive the following wel-
come window:
1 Press the OK button to proceed to the next page.
2 On the next page, select the desired language by pressing
=
the arrow button
or
button.
The settings window is displayed:
NOTE: Also observe the information messages displayed on the
screen. These will help you to set the correct values. Also with
regard to further operation, information messages are dis-
played.
3 Now successively set the desired values. In doing so,
observe the following:
=
, and again press the OK
- By using the arrow buttons
displayed values,
- By using the arrow buttons
between the individual setting possibilities.
4 Then highlight the OK field by using the arrow button
=
=
or
behind adopt, and press the OK button.
The next window is displayed:
NOTE: The displayed values for the start and stop frequency
can normally be maintained.
5 If desired, change the values for the start and stop fre-
quency by using the arrow buttons
6 By means of the arrow buttons
channels to be selected: all channels, or channels that
are free-to-air only.
7 Then highlight the OK field by using the arrow button
=
=
or
next to start scan mode, and press the OK
button.
The scan mode is started. The screen dialog thereby pro-
vides information on the progress of the channel search.
NOTE: By pressing the EXIT button, you can stop the scan
mode at any time.
As soon as the search is completed, an according message
is displayed. Acknowledge this and the following message
by OK, in order to proceed to the TV replay.
=
=
or
, you change the
=
=
or
, you switch
=
or .
=
or , you define the
PERATION
O
7
Advertisement
Table of Contents
