Queue Policing - Planet Networking & Communication IGS-5225-8T2S2X User Manual

4.4.1.2 Queue Policing

This page allows you to configure the Queue Policer settings for all switch ports.. The Queue Policing screen in
appears.
The page includes the following fields:
Object
• Port
• Enable (E)
• Rate
•
Unit
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
Figure 4-4-1-2 : QoS Ingress Port Classification Page Screenshot
Description
The port number for which the configuration below applies.
Enable or disable the queue policer for this switch port.
Controls the rate for the queue policer. This value is restricted
to 25-13128147 when "Unit" is kbps, and 1-13128 when "Unit" is Mbps. The rate
is internally rounded up to the nearest value supported by the queue policer.
This field is only shown if at least one of the queue policers are enabled.
Controls the unit of measure for the queue policer rate as kbps or Mbps.
This field is only shown if at least one of the queue policers are enabled.
User's Manual of IGS-5225-8T2S2X & 8P2S2X series
246
Figure 4-4-1-2