How To Save The Position 1-4 Preset Positions - Datavideo iCAST MINI Instruction Manual

15. Lock/Unlock: This is the switching button for locking or unlocking. Once it
is locked, the "CAMERA Control" area can not be used.
16. Speed Control Slider: This slider allows you to control the speed for
zooming in and zooming out when the "Zoom In" or "Zoom OUT" button is
pressed. Moreover, it also allows you to control the speed of the joystick in
the "CAMERA CONTROL" area. Please slide the slider to the up side to
increase the speed and slide the slider to the down side to decrease the speed.
17. PTZ Control Joystick: This joystick allows you to control the direction of the
connected PTZ camera.
18. Position 1-4: You can see the thumbnails of the Presets 1-4 from this area.
19. Store Button: Once the parameters for your desired preset position is
adjusted, you can press this button to activate the preset position 1-4 to save
your desired preset positions.

5.2.1. How to save the Position 1-4 Preset Positions

Please follow the steps below to save the Position 1-4 preset positions. Note:
Due to that the iCAST MINI's Graphic Key function is achieved by the RTSP
stream function of the PTZ camera. So, you can use the Graphic Key function
only when the DVIP protocol is selected to be the connection setting.
1. Please adjust your desired preset position and parameter settings in
advance.
2. Please tap the "STORE" button , and then you can see the Position 1-4
area is shown in the following diagram.
33