Update Usb Module Software; Replace Usb Module - Graco XM PFP Repair Parts

Hide thumbs Also See for XM PFP:

Table of Contents

Update USB Module Software

1. Remove four nuts (21) and then remove front and

rear shrouds (19, 20).

ti19926a1

2. Use software token 16P644. See Graco Control

™

Architecture

Module Programming manual for

instructions.

NOTE: Upgrade all modules in the system to the

software version on the token, even if you are

replacing only one or two modules. Different soft-

ware versions may not be compatible.

All data in the module may be reset to factory

default settings. Record all settings and user prefer-

ences before the upgrade, for ease of restoring

them following the upgrade.

The latest software version for each system can be

found at Tech Support at www.graco.com.

3A2989B

1. Remove Shroud and Front Panel of Control Box,

see page 10.

2. Disconnect CAN cables and USB cable from USB

module (519).

3. Remove two mounting screws from USB module

and remove module from base.

519

4. Follow steps in reverse order to install new USB

module.

5. Load software. See Update USB Module Soft-

ware.

Repair

Table of Contents