Update Fluid Control Module (Fcm) Software; Replace Fluid Control Module (Fcm); Replace High Power Temperature Control Module (Hptcm) - Graco XM PFP Repair Parts

Repair
Update Fluid Control Module (FCM)
Software
1. Remove four nuts (21) and then remove front and
rear shrouds (19, 20).
21
20
19
ti19926a1
2. Use software token 16P644. See Graco Control
™
Architecture Module Programming manual for
instructions.
NOTE: Upgrade all modules in the system to the
software version on the token, even if you are
replacing only one or two modules. Different soft-
ware versions may not be compatible.
All data in the module may be reset to factory
default settings. Record all settings and user prefer-
ences before the upgrade, for ease of restoring
them following the upgrade.
The latest software version for each system can be
found at Tech Support at www.graco.com.

Replace Fluid Control Module (FCM)

NOTE:
The USB module does not need to be removed prior to
replacing the FCM.
1. Remove Shroud and Front Panel of Control Box,
see page 10.
2. Remove all cables from FCM (518). Take note of
cable locations.
12
3. Loosen four mounting screws (535).
518
535
4. Slide FCM up and out of keyhole slots.
5. Follow steps in reverse order to install new FCM.
6. Load software. See Update Fluid Control Module
(FCM) Software.
7. Most of the system configuration is stored in the
FCM. Use the display to change the configuration to
the values in the old FCM. See XM PFP operation
manual for instructions.
Replace High Power Temperature Control
Module (HPTCM)
1. Turn system main power switch OFF.
2. Open junction box.
3. Unplug all connections on the HPTCM.
4. Remove screws securing HPTCM then remove
HPTCM.
5. Remove access door on new HPTCM. Set rotary
switch to the same number as the old module.
B module = 1. Hose module = 2. A module = 0.
6. Use screws to install HPTCM.
7. Reattach HPTCM connections.
8. Close junction box.
r_312359_313289_26
535
3A2989B