Replace Alarm; Display - Graco XM PFP Repair Parts

Replace Alarm

1. Remove Shroud and Front Panel of Control Box,
see page 10.
2. Disconnect alarm wires from alarm (517).
3. Unscrew alarm (517) and replace.
4. Screw in new alarm. Reconnect alarm wires.
5. Reinstall front panel of control box and reinstall
shrouds.

Display

Upgrade Software
NOTICE
To avoid damaging circuit board, wear a grounding
strap.
Use software token 16P644. See Graco Control Archi-
™
tecture Module Programming manual for instructions.
NOTE: Upgrade all modules in the system to the
software version on the token, even if you are
replacing only one or two modules. Different soft-
ware versions may not be compatible.
All data in the module may be reset to factory
default settings. Record all settings and user prefer-
ences before the upgrade, for ease of restoring
them following the upgrade.
The latest software version for each system can be
found at Tech Support at www.graco.com.
1. Remove Shroud and Front Panel of Control Box,
see page 10.
3A2989B
2. Remove four screws (512) then remove access
cover (511).
512
511
T
517
3. Insert and press token (T) firmly into slot.
NOTE:
There is no preferred orientation of token.
4. Turn power on.
5. The red indicator light (L) will flash until new soft-
ware is completely loaded.
6. Turn power off.
7. Remove token (T).
8. Use screws (512) to install access cover (511).
Repair
Battery
L
r_xm1a00_312359_313289_2a
13