Table of Contents
Advertisement
Date Search
The date search function memorizes the start and end positions of recordings you made on a specific
day so you can easiiy locate those positions later as long as the cassette is left in the camcorder.
Note: Be sure that the date and time are set.
Attach a power source and slide the CAM/
A OFF/VIDEO switch to VIDEO.
2 Press the DATE button (the DISPLAY button on
the remote control) to display "SEARCH" in the
viewfinder or on the LCD monitor.
^ Press the REW button to search for the start
position from which you last made a recording
or the FF button to recording end position. " 44
SEARCH" will appear while the start position is
being searched for; "SEARCH ►► ", while die
end position is being searched for.
A When the required position is located, the cam¬
corder enters the stop mode and "SEARCH"
disappears from the viewfinder or LCD moni¬
tor.
r-
1
Note: if you have ejected the cassette, this
function will not operate with that cassette,
(When a cassette is Inserted-and the recording
is started, the position is identified as the record¬
ing start position on that day.)
Note: If the clock battery is not inserted, the
date search function does not operate when
the battery providing the power to the cam¬
corder is removed.
Note; When the cassette was recorded by
another camcorder, the date search function
does not operate,
Note;
The date search function is released
when you press the STOP button during date
search mode,
Note; if the recorded time Is less than 30 sec¬
onds, the date search function may not oper¬
ate normally.
Using j\/l©mory
■
1 2
o
The linear time counter memory stops a rewinding tape at approximately "0:00:00M". This feature helps
in locating a specific point in the tape to which you wish to return. An example might be that you have
recorded some tape that you have already watchedyou continue recording but do not care to
watch the tape you recorded earlier. The memory feature returns you to the beginning of the most
recent recording.
1 Start recording or playback of a cassette. Press
the COUNTER RESET button on the remote
control at the point to which you wish to return.
The linear time counter dears to "0:00:00".
2 Press the STOP button to stop playback, or press
the Start/Stop button recording and set the
CAM/OFF/VIDEO switch to VIDEO.
^ Press the DISPLAY button on the remote control
so the linear time counter with memory is dis¬
played as shown in the figure.
Note: You can also use the memory function
by specifying "LCD/LINE" for the DISPLAY item
on the menu screen.
Press the REW button and the tape stops at
approximately where you reset the linear time
counter. This feature works in FF as well.
VM-H675tA/VfYt~£575LA/VfVLE573LA
E4S
Advertisement
Table of Contents
