Table of Contents
Advertisement
Charging th© Batfsry
- -
The first step is to set the battery for charging, To charge the battery,, attach if to the camcorder, and
connect the VM-ACE5A AC adaptor. Charge the battery at a temperature range of50°F(W°C) - 86°F
(30°C) to prevent damage to the battery.
Note: This camcorder operates with a lithium ion battery such as VM-BPL13/VM-BPL30/VM-BPL60,
Note: We cannot be responsible for any malfunctions of the camcorder which occur when you use bat¬
tery packs other than those specified.
Charge the battery on a fiat surface this is free of
vibration,
Make sure the CAM/OFF/VIDEO switch is set-
to OFF position.
CAM/OFF/VIDEO Switch
2 Attach the battery pack to the camcorder.
# Place the battery on the guide platform and
slide it down so that it fits into the camcorder.
Note: Always attach a battery only by the pro¬
cedure described here. Attaching a battery
forcibly could damage it.
*1
Plug the AC adaptor power cord into an AC
outlet.
Make sure that the wide blade fits into the wide
slot.
If it doesn't fit, fry reversing if.
If the
blades still do not fit fully info the outlet, either
contact an electrician to replace your obsolete
outlet, or use a polarized cord or outlet access¬
ory.
/J Connect the AC adaptor DC plug to the DC IN
jack of the camcorder.
Charging will start within five seconds. During
charging, the BAIT. CHARGE indicator of the
camcorder will flash or light to give you a refe¬
rence of the charged level.
Note: if the BAIT. CHARGE indicator flashes
once every two seconds, the battery could be
defective.
Note: The BATE CHARGE Indicator will not light
at all when the AC adaptor is defective.
Note: You can use the battery before it is com¬
pletely charged.
Note: When charging is complete, the BAIT.
CHARGE indicator on the camcorder will light
IF the fully charged battery is removed and
then reattached, the camcorder will again
enter the charge mode, and the BATT.
CHARGE indicator will flash. It will take a few
minutes for the camcorder to enter the charge
complete status.
Note:
Charging at low temperatures will
decrease charge capacity.
CJ After charging is complete, disconnect the AC
adaptor DC plug from the camcorder.
6 Disconnect the AC plug from the AC outlet.
7 1 A-fach the battery from the camcorder.
Note:
Always remove the battery from the
camcorder after use.
Note: Charging will not be performed when
the CAM/OFF/VIDEO switch of the camcorder
Is set to CAM or VIDEO. However, if recording
pause continues for more than 5 minutes in the
CAM mode, the camcorder will automatically
turn off, after which charging will start. If the
sub-power switch is set to LOCK, charging will
be performed even when the CAM/OFF/ViDEO
switch is set to CAM.
Note: If the DC plug is disconnected when the
battery is attached and
the
CAM/OFF/VIDEO
switch Is set to C AM or VIDEO, the camcorder
will turn off once, but then automatically turn
on again. Note that the battery will discharge
if the camcorder is left as is.
VM-H675LA/VM-E575LA/VM-E573LA
E17
Advertisement
Table of Contents
