TROUBLESHOOTING GUIDE
if the unit fails to perform as expected, please read through the instructions again and check the table below:
Symptom
Causes
Esto)
[Fi tcey ay
There is no sound.
¢ The AC cord is not connected properly.
¢ Correct the connection.
'
¢ Anincorrect function button was pressed.
¢ Press the function button to select the correct input.
* There is a bad connection between systems.
e Correct the connection.
¢ Excessive voltage was applied to a speaker ter-
minal, which tripped the amplifiers voltage-pro-
tection breaker.
¢ Disconnect the AC cord, correct the condition,
including speaker connections, and connect the
AC cord again.
* Disconnect the AC cord, correct the condition, in-
cluding speaker connections, and then connect the
power again. Turn on the power by pressing the
POWER button.
¢ If the clock is flashing radio presetting or timer
setting is canceled, set it again.
=
2
id
There is constant, wave-like
@ Check the antenna connection.
¢ Correct the tuning.
* Install an outside antenna.
¢ The antenna is not connected properly.
¢ The receiver is not correctly tuned.
¢ The signal is weak.
¢ The system is picking up outside noise.
¢ Change the location or direction of the antenna.
¢ Keep the antenna away from the flat cable.
¢ Turn the unit to a different orientation.
¢ Move the unit away from other electrical
appliances, like a TV or fluorescent lights, or move
the appliances.
¢ Change the orientation of the antenna.
¢ Replace the antenna with one that has the correct
orientation.
back in Dolby mode.
7
* The playback head is dirty.
.
* Clean the head.
¢ An erasure prevention tab on the tape has been | * Cover the erasure prevention tab hole with tape.
broken off.
*. There is an incorrect connection.
¢ Correct the connection.
¢ Clean the head.
¢ The recording head is dirty.
¢ The erasure head is dirty.
* Clean the erasure head.
;
7
« A CrOz or metal tape is being used.
¢ Use a normal tape.
|
CD does not play.
* The disc was inserted incorrectly.
e Insert the disc with the label facing up.
* The disc is dirty.
* Clean the disc.
se
¢ There is condensation on the lens.
¢ Wait about an hour and try again.
Reception is noisy.
The sound is distorted.
¢ There is multipath distortion.
Recording is impossible.
- 'Gassette
deck
section
_
Erasure is impossible.
¢ The player is paused.
¢ Press the Il button to release pause.
The output sound is not stereo. | * A KARAOKE function is selected.
¢ Cancel the KARAOKE function.
To reset
If an unusual condition occurs in the display window or the cassette
deck, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the ll button.
Everything stored in memory after purchase is canceled.
3 Press the POWER button to turn on the power.
4 Set the clock, radio presetting and timer settings as before.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and carry out steps 2 to 4.
77