Table of Contents
Advertisement
Introduction
If your Humminbird control head has a built-in Ethernet connector, the unit can be connected to the Ethernet network. When you
connect two units together, data is shared between the units. You can use an Ethernet Switch to link multiple Humminbird control
heads, share transducers, and more.
This manual will guide you through the following network setup instructions:
1. Connect two or more Humminbird units together
2. Power On
3. Customize your Humminbird Ethernet Network
4. Share Waypoints
Alarms, navigation, sonar data, and the menu system are all affected by the Ethernet network settings. We
encourage you to read this manual completely so that you may understand the full capabilities of your Humminbird
Ethernet network.
5
Introduction
Advertisement
Table of Contents
