Power On - Humminbird DUAL HELIX STARTER KIT HWAL-TRANSOM Installation And Operation Manual

Power On

When you have installed an Ethernet network, the power on process is the same as powering on a single control head, however, your
transducer connections will determine how the control head starts normal operation.
Alarms, navigation, sonar data, and the menu system are all affected by the Ethernet network settings. We
encourage you to read this manual completely so that you may understand the full capabilities of your Humminbird
Ethernet network.
Power On
1. Press the POWER key.
2. When you power on the control head, it will start Normal mode automatically if a functioning transducer is detected.
∆ If a transducer is not attached to the control head, but there is another transducer connected to the network, press the
MENU key when the Title screen is displayed. Select Normal from the Start-up Menu. (This step is only required for first-
time setup or after defaults have been restored on the unit.)
∆ If you are prompted to select a sonar source at start up, see Select a Sonar Source for more information.
3. Repeat steps 1 and 2 until all the control heads in the network are powered on.
Power On 10