Share Waypoints - Humminbird DUAL HELIX STARTER KIT HWAL-TRANSOM Installation And Operation Manual

Share Waypoints

When you network control heads, waypoints are shared between control heads by default. You will observe the following:
∆ When a waypoint is marked on one control head, the waypoint will also be displayed on the other control head. If the waypoint
is saved, it will be saved to the local control head where it was marked.
∆ Routes: When waypoints are viewed on both control heads, you can build a route from either control head using the shared
waypoints. The route is saved to the control head where it was created.
NOTE: Routes and tracks are not shared on the network. On HELIX models, when the units are powered off, the waypoint data is saved
only on its local control head where it was originally marked.
NOTE: On HELIX models, although the navigation data is viewable, it is not copied on every control head. In other words, a new route
will be saved to the control head where the route was initiated. If you edit navigation data, the data will be saved back to its local
control head.
Turn Share Waypoints On/Off
NOTE: APEX and SOLIX control heads on a network will share waypoints automatically. Turning on Share Waypoints enables your APEX
or SOLIX control heads to share waypoints with HELIX control heads.
APEX/SOLIX Series
1. Press the HOME key.
2. Select Nav Data.
3. Under Options, select Waypoints > Share Waypoints.
4. Tap the on/off button, or press the ENTER key, to turn it
on or off.
5. Repeat steps 1 through 4 on each control head so that
each control head is sharing its waypoint data on the
network.
GPS and Waypoints Overview
HELIX Series
1. Main Menu: Press the MENU key twice.
2. Select the Network tab > Share Waypoints.
3. Press the RIGHT Cursor key to turn it on or off.
4. Repeat steps 1 through 3 on each control head so that
each control head is sharing its waypoint data on the
network.
28