Select A Temperature Source - Humminbird DUAL HELIX STARTER KIT HWAL-TRANSOM Installation And Operation Manual

Select a Temperature Source

Temperature sources can be detected from a transducer's built-in temperature feature or from optional-purchase temperature/
speed accessories connected to the network. When you first set up the network, the control head will automatically choose the
temperature source connected to it. Use the instructions below to select sources based on your preferences.
APEX/SOLIX Series
The Temp (1), Temp (2), Temp (3), and Temp (4) options within
the Network Data Sources menu represent the digital readout
positions on the screen. You can choose a different temperature
source for each digital readout, so each control head can display
up to four temperature digital readouts on the display.
Auto-Configure: When Auto-Configure is turned on, the sources
are selected automatically by the control head. When Auto-
Configure is turned off, you can select sources based on your
preferences.
1. Open the Network Data Sources Menu.
2. Select Temp (1), Temp (2), Temp (3), or Temp (4).
3. Select Auto-Configure. Tap the on/off button, or press the
ENTER key, to turn it off.
4. Select a source from the list.
5. Repeat steps 2 through 4 to select a different temperature
option.
6. Repeat the steps in this section on each control head to
choose a temperature source for each tab. You can select
the same source or a different source.
7. For information on sharing temperature sources across
the Network, see Understand Global Settings.
Selecting a Temperature Source (APEX/SOLIX)
HELIX Series
The T1, T2, T3, and T4 tabs at the top of the Network Source
Setup dialog box represent the digital readout positions on
the screen. You can choose a different temperature source for
each digital readout box, so each control head can display up
to four temperature digital readouts on the display.
NOTE: There will be less than four temperature tabs
displayed if there aren't four temperature sources
connected to the network.
1. Open the Network Source Setup dialog box.
2. Select the tab for T1, T2, T3, or T4.
3. Select: Press the DOWN or UP Cursor keys to choose a source.
4. Press the RIGHT Cursor key or the CHECK/INFO key to select
it (check mark = selected).
5. Repeat steps 2 through 4 to select a different temperature
tab.
6. Save: Press the EXIT key twice to close the dialog box.
Network settings are saved even after the unit is powered off.
7. Repeat the steps in this section on each control head to
choose a temperature source for each tab. You can select
the same source or a different source.
Local Setup: To use separate temperature sources for each
control head, repeat these steps on each control head until
you've set a temperature source for each unit and each digital
readout.
Shared Setup: To use the same temperature sources on more
than one control head, repeat these steps on each control
head and select the same temperature sources on all units.
Selecting a Temperature Source (HELIX)
23 Temperature Source Overview