Sony HANDYCAM DCR-DVD910 Operating Manual page 21

O Notes
• Disconnect the AC Adaptor fi'om tile DC IN
jack holding both the camcorder mid tile DC
plug,
To remove the battery pack
(_) Turn tile POWER switch te OFF
(CHG).
@ Press and hold the BATT (battery)
release button attd remove the battery
pack in the direction of the arrow.
BATT (battery) release button
To checkthe remaining battery
(Battery Info)
Set the POWER switcll toOFF (CHG),then
press DISP/BATT INFO.
DISP
BATT INFO
After a while, the approximate recordable
time and battery information appear %r
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
Remaining battery (approx.)
m
g
GO
g.
(J Notes
• When you renlo_ e the baltcry pack or lhe AC
Adaplor, make sure lllz,t tile _ (Mox ie) lamp/
(Still) lamp (p. 231/ACCESS lamp (p. 27)/
access lamp (p. 29) are turned off.
• When you store the batlery pack. fillly discharge
the baacry betPrc storing il lbr an extended
pcriod (p. 115).
To usea powersource from a wall
outlet(wall socket)
Make the same conllectiolls as yetl do when
charging the battery pack. The battery pack
will not lose its charge in this case.
E"
Recording capacity (approx.)
Chargingtime
Approximate time (rain.) required when
you fully charge a fully discharged battery
pack.
NP-FH50 135
NP-FH60 135
(supplied)
NP-FH70 170
NP-FH 100 390
Continued._
21